The ID6100 has been discontinued by the manufacturer, though units are still available through industrial surplus and repair specialists. Radwell International Manuals & Documentation: Official technical guides and brochures can be found via Danieli Automation's website or industrial document repositories like Suppliers: New-in-box and refurbished units are often listed on Radwell International MRO Global Solutions calibration steps for a repair, or do you need help finding a modern replacement for this discontinued model?
Connect the integrated liquid cooling jacket to a clean, continuous industrial water supply if the unit is positioned near active radiant heat zones.
Products › Automation › ID6000 Loop detectors ‹ Danieli
The CCD linear-array photo sensor requires careful alignment to focus properly on the IR emission from the hot product. Power Supply: The units generally operate on 20-30VDC . id6100 danieli manual hot
Implement an air-purge system over the optical window lens. A steady stream of dry, oil-free compressed air prevents steam, scale dust, and water droplets from settling on the lens, which can cause reading dropouts. Electrical Interface and Calibration
Outputs real-time information via standard digital triggers (for raw material presence) alongside analog feedback mechanisms to indicate precise spatial deviation.
: Providers like Radwell International offer discontinued ID6100 units and repair services. The ID6100 has been discontinued by the manufacturer,
Without the , a maintenance team might take 4 hours to re-commission a stand after a module failure. With the manual:
| | Value/Specification | | :--- | :--- | | Detectable Spectrum | 830 to 1000 nm (Near-Infrared) | | Detectable Object Temp. | 700 °C to 1200 °C (1300 °F to 2200 °F) | | Field of View (Vertical) | 45° / 30° (Selectable) | | Field of View (Horizontal) | 0.5° | | Position Resolution | 0.1° | | Operating Temperature | 0 °C to +50 °C | | Storage Temperature | -5 °C to +80 °C | | Power Supply | 24 VDC ± 20% | | Power Consumption | Max 7.2 W (300 mA at 24 VDC) | | NPN/PNP Outputs | Open Collector, Max 30 VDC, Max 200 mA | | Analog Loop Pos. Output | Voltage (POS) or Current (IPO) | | Response Time | < 1 ms | | Auto-Test Supply | 24 VDC (e.g., for signal simulation) | | Degree of Protection | IP65 (Dust-tight and protected against water jets) | | Weight | ~ 2.5 kg |
Products › Automation › ID6000 Loop detectors ‹ Danieli Products › Automation › ID6000 Loop detectors ‹
: Locate the internal potentiometer on the rear interface panel. Adjust the sensitivity threshold slowly:
loop scanner tracks materials through a specialized, non-contact infrared scanning method: